Recommended connection for external LEDs
The cameras have a Status LED that indicates the hardware and operational status of the camera. The LED indicates the following behavior:
Flashing orange - the camera is initializing. This happens first.
Solid orange - the camera is loading the FFC parameters from memory. This process can take up to 20 seconds.
Flashing green - the camera is performing a lengthy operation or is streaming video data.
Solid green - the camera is ready for operation.
Flashing red - the camera has issued a warning on the latest command received.
Solid red - the camera has experienced an unrecoverable error. Go to Technical Support if this happens.
The PL-A series board level cameras have an external connector to accommodate a panel mount LED.
Recommended connection for external LEDs
External LED connector reference J4
Use 3-pin 1.25mm cable housing Molex 51021-0300 and crimp terminals Molex 50079-8100